Models > WM1832CW > Parts

WM1832CW (WM1832CW /00) LG Washer - Parts

Jump to:

1 - 12 of 91
Keep searches simple, eg. "belt" or "pump".
This is a drain pump motor assembly for washers. This OEM part is responsible for removing water from the washer during the drain part of the cycle. When this part is clogged, damaged or defective it ...
In Stock
Order now and your part arrives by Nov 21
Regulate the washer?s hot water supply with this single-solenoid inlet valve. It links the household hot water line to the internal filling system, opening on a control request and closing when the fi...
In Stock
Order now and your part arrives by Nov 21
A rubber barrier around the rotating drum shaft helps protect the washer?s tub bearings from water and detergent. This rear tub shaft seal sits in the rear outer tub, keeping wash water out of the bea...
In Stock
Order now and your part arrives by Nov 21
This door lock and switch assembly holds the door closed during operation and reports its status to the main control board. Secure door locking allows a front-loading washer to begin and complete its ...
In Stock
Order now and your part arrives by Nov 21
Water leaves the washer tub through this flexible tub-to-pump drain hose before reaching the drain pump housing. Its corrugated bellows section bends with tub movement, helping maintain the connection...
In Stock
Order now and your part arrives by Nov 21
The motor rotor position sensor monitors the direction and speed of the spinning rotor and communicates this information to the electronic control board. If your washer is displaying an LE error code ...
In Stock
Order now and your part arrives by Nov 21
This rubber tub seal fits between the front and rear halves of the washing machine’s outer tub to prevent water leaks. It helps maintain proper washing performance and may need replacement if you noti...
In Stock
Order now and your part arrives by Nov 21
In Stock
Order now and your part arrives by Nov 21
$276.32
This rear drum support, also known as a spider or spinner support, is a critical structural component in select washing machines. Featuring a triangular design with three metal arms, it securely holds...
In Stock
Order now and your part arrives by Nov 21
$38.45
The removable filter and cap assembly provides access for routine cleaning and seals the filter opening when tightened. Replace the damaged assembly to restore the debris trap and sealed access point....
In Stock
Order now and your part arrives by Nov 21
In Stock
Order now and your part arrives by Nov 21
$26.19
The locking pin is used to hold the shock absorber on the washer. There is a pin used at the bottom and top of the shock absorber. Sold individually.
Special Order
1 - 12 of 91