WM1388HW (ABWEEUS) LG Washer - Parts
Jump to:
Keep searches simple, eg. "belt" or "pump".
$65.37
This is a drain pump motor assembly for washers. This OEM part is responsible for removing water from the washer during the drain part of the cycle. When this part is clogged, damaged or defective it ...
In Stock
Order now and your part arrives by Nov 22
$37.35
Regulate the washer?s hot water supply with this single-solenoid inlet valve. It links the household hot water line to the internal filling system, opening on a control request and closing when the fi...
In Stock
Order now and your part arrives by Nov 22
$36.25
A rubber barrier around the rotating drum shaft helps protect the washer?s tub bearings from water and detergent. This rear tub shaft seal sits in the rear outer tub, keeping wash water out of the bea...
In Stock
Order now and your part arrives by Nov 22
$82.45
This door lock and switch assembly holds the door closed during operation and reports its status to the main control board. Secure door locking allows a front-loading washer to begin and complete its ...
In Stock
Order now and your part arrives by Nov 22
$46.07
This washer rear tub ball bearing supports smooth drum rotation. Located at the back of the outer tub, it supports the inner drum shaft and reduces friction during washing and spinning. Installing a r...
In Stock
Order now and your part arrives by Nov 22
$142.60
Cold water reaches the washer tub and dispenser through this triple-solenoid inlet valve assembly. Its three controlled outlets open during selected cycle stages, directing water where needed before c...
In Stock
Order now and your part arrives by Nov 22
$38.45
The removable filter and cap assembly provides access for routine cleaning and seals the filter opening when tightened. Replace the damaged assembly to restore the debris trap and sealed access point....
In Stock
Order now and your part arrives by Nov 22
$57.30
Tub bearing. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.
On Order
$26.19
The locking pin is used to hold the shock absorber on the washer. There is a pin used at the bottom and top of the shock absorber. Sold individually.
Special Order
$48.35
The outer water chamber around the washer pump is formed by this plastic drain pump casing. It links the tub drain hose, pump motor, and debris filter, holding the connected components in position whi...
In Stock
Order now and your part arrives by Nov 22
$16.45
This hose clamp applies pressure around the hose end, holding it firmly against its fitting during operation. A secure hose connection helps keep water contained inside the appliance. This OEM part is...
In Stock
Order now and your part arrives by Nov 22
$23.05
Drain residual water before cleaning the pump filter with this washer cleanout hose. The flexible rubber hose attaches to the drain pump filter housing, giving remaining water a controlled outlet from...
In Stock
Order now and your part arrives by Nov 22