11029802891 Kenmore Washer - Parts

This part goes on the agitator retaining bolt.

Sold Individually.

This part holds the bleach until it is ready to be released into the cycle.

Metallic screw that is less than an inch long. Does not include the plastic washer.

This is used in your direct drive washer that has a neutral drain.

This kit comes with the clamps.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This hose clamp is sold individually.

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the wa...