Models > 11020642991 > Parts

11020642991 Kenmore Washer - Parts

Jump to:

1 - 12 of 158
Keep searches simple, eg. "belt" or "pump".
Commonly referred to as dog ears, these agitator directional cogs are manufacturer approved replacement parts that come in a package of 4 and are usually used with direct drive washing machines. We re...
In Stock
Order now and your part arrives by Mar 19
This suspension spring is a genuine OEM replacement part for a variety of washers and washer-dryer combos. The primary purpose of the suspension spring is to support the outer tub and keep the tub ste...
In Stock
Order now and your part arrives by Mar 19
There are many symptoms that may indicate an issue with your water inlet valve. These can include your washer not filling with water, it will not stop filling, the washer is leaking, or it is both fil...
In Stock
Order now and your part arrives by Mar 19
When the lid switch on your washer is activated, it sends a signal that the lid is shut and that the machine can operate through the wash cycles. If your washer will not start, drain, agitate, or spin...
In Stock
Order now and your part arrives by Mar 19
This bolt is a genuine OEM replacement part, used to secure the agitator in your washing machine. Overtime the bolt can become worn out due to the vibrations of the washer, and will need to be replace...
In Stock
Order now and your part arrives by Mar 19
This tub spring is a genuine OEM replacement part for your washing machine and is sold individually. There are other names that the tub spring goes by, such as the suspension spring, balance spring, o...
In Stock
Order now and your part arrives by Mar 19
The thrust spacer is a genuine OEM part that is more commonly known as a retainer ring. The spacer is made of white plastic and measures approximately 2.5 inches in diameter. This part is found in bet...
In Stock
Order now and your part arrives by Mar 19
This package of pads contains three tub wear pads.
In Stock
Order now and your part arrives by Mar 19
This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...
In Stock
Order now and your part arrives by Mar 19
Stop leaks before they start with this outer tub seal. It fits between the tub and base to keep water inside where it belongs. At about 2 inches across, this sturdy black gasket is built to last. Inst...
In Stock
Order now and your part arrives by Mar 19
Sold Individually.
In Stock
Order now and your part arrives by Mar 19
This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
In Stock
Order now and your part arrives by Mar 19
1 - 12 of 158