All Installation Instructions for Kenmore Washer 11072676110

Customer:: Roger from Millis, MA
Parts Used:: 285222
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Wrench set

Washer Had A Continuous Moan And Vibration

I disconnected the drive belt from the motor and ran the motor to isolate it from the rest of the mechanisms. This was the noise. I disconnected the water lines and electrical cord,laid the machine front down. I disconnected the motor plug,removed the two bracket to body bolts and lifted the motor out to the bench. I then transferred the bracket to the new motor and reversed the procedure to install the motor. The most difficult part was raising the machine back up alone,I suggest a helper.

Was this instruction helpful to you?

Customer:: sean from easthampton, MA
Parts Used:: W10820036
Difficulty Level:: Easy
Total Repair Time:: More than 2 hours
Tools:: Nutdriver, Screw drivers

dryer wouldn't start

I found on youtube that there are directions to repair. Dryer problems are usually one of three things, the door switch being one of them. i checked this last (should have been first). ordered the part( about 65% off sear's cost) and it came in one day! It went on really easy as long as you knew from repair video how to access inside. almost spent $400.00 on a new one.

Was this instruction helpful to you?

Customer:: Bruce from Yankton, SD
Parts Used:: W10814296
Difficulty Level:: A Bit Difficult
Total Repair Time:: 1- 2 hours
Tools:: Pliers, Screw drivers, Socket set

Had issues with removing the inner tub

Had a lot of corrosion on the shaft area and had a hard time removing the inner tub but after some WD-40 and unprintable words and labor it popped off. Cleaned everything up, shaft, inner drum and outer drum. After that everything was a piece of cake. Thanks for the help!

Was this instruction helpful to you?

11072676110 Kenmore Washer - Instructions