11027112600 Kenmore Washer - Parts

It connects from the pump to the back panel. The clamp is not included.

This spring is used on the leveling components in a washer. Please note, this spring may differ in appearance, but functions the same as original.

This part goes on the agitator retaining bolt.

This idler shaft retaining ring is well under an inch long and is made of metal.

This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers,...

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shakin...

This is used in your direct drive washer that has a neutral drain.

This kit comes with the clamps.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This hose clamp is sold individually.

This is a pack of three suspension pads for your washer. The suspension pads in your washer are found underneath the tub and prevent the rotating metal parts from grinding on one another. If your susp...

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...