Models > 11047701801 > Instructions

11047701801 Kenmore Washer - Instructions

Jump to:

All Instructions for the 11047701801

Customer:: Peter from Naples, FL
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers, Wrench (Adjustable)

My washer was not draining

It was real easy. I disconnected the wiring as shown in the video. I took the clamps off the drain pump , once off I slid the old drain pump off. I slid the new pump on , attached the hoses with the clamp provided and connected the wiring. Just follow the video and you will find it to be very easy! Thanks Parts Select for saving me money

Was this instruction helpful to you?

Customer:: DAVID from HARRAH, OK
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Pliers

would not drain or spin

Replace water pump

Was this instruction helpful to you?

Customer:: Larry from Gardena, CA
Parts Used:: WP8183202
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Door would not close, piece on the bottom of the hinge that pulled door in was broken.

Remove the two screws holding the hinge to the washer body. Lift up on the hinge to remove from the washer. Remove all the screws holding the inner door piece to the outer cover. Remove the old hinge, replace with the new one. Put the two door pieces back together and tighten the screws. Place hinge back in on the washer body and push down. Replace screw at top and bottom. Close door and start using.

Was this instruction helpful to you?

Customer:: kevin from elizabethton, TN
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Pliers, Screw drivers, Socket set

Washer washed cloths then would not rinse

Just went by instructions provided by parts web site

Was this instruction helpful to you?

Customer:: Susan from Rock Hill, SC
Parts Used:: WPW10121596
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Divider Broke

I just put the divider in the dispencer

Was this instruction helpful to you?

Customer:: John from Norman, OK
Parts Used:: WPW10110225
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Pliers

Water flow problem resulting in f20 error code

Unplugged electric cord and turned off water supply. Remove 3 screws @ rear of washer and removed top panel. Removed clamps on hoses and electrical connector to flow meter, removed and replaced with new flow meter. Replaced the top panel, turned on water supply and plugged unit in. Finished in less than 15 minutes. Saved myself several hundred $

Was this instruction helpful to you?

Customer:: Julie from Milton, PA
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Drain Pump Stopped working

Took of the panel, unscrewed the old drain, screwed the new drain in. Very very simple to do! The first part I received leaked, I called customer service and they gave me a refund and express shipped a new part - no questions asked. Very good customer service!

Was this instruction helpful to you?

Customer:: JANICE from MANHATTAN, KS
Parts Used:: WPW10110225
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Pliers

I was having the hf code constantly beeping and couldn't run a full cycle.

I opened the top by taking four screws from the back and lifted the top. The part to be replaced was clearly in view. I opened the clamps on the hoses, pulled the hoses off, removed the wires, and reversed the process with the new part. The washer works great now! I ordered the part on a Friday, and it was delivered the next day, even though I didn't pay for overnight!

Was this instruction helpful to you?

Customer:: brian from turners falls, MA
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Pliers

buzzing noise water not draining

unplug washer from outlet carefully tilt back to get at underside of washer remove bottom panel. pump location lower right front. remove two hoses from back using pliers keep note on hose location. remove two bolts on underside of machine slide pump to the right to release from rubber holders to install reverse the process also good idea to use the new hose clamps that come with your new pump and the rubber mounts if they are included

Was this instruction helpful to you?

Customer:: Mike from Columbus Grove, OH
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Pliers

F21 code

Thank You so much for the other stories folks wrote on here! We were getting an F21 code on a regular basis. After finding a necklace and about $2.50 in change in the filter tray we found the problem. Over time I thought the washer was getting louder but it was so gradule that we really did not realize it.I had read other posts on here and ordered a new pump. After taking out 3 screws and 2 clamps the pump came right out and went in just as easy. Less than 15 minutes and we were back in business with a wisper quiet washing machine,Thanks Again everyone, Mike D.

Was this instruction helpful to you?

Customer:: jeremiah from royalton, MN
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Pliers, Socket set

drain pump impellar busted

I drained the water out of the pump area. Then took off all clamps and holding brackets. Next I pulled off the quick connect power plug. Then I put new pump in the way I took old pump out. The hardest part was unscrewing the bracket from underneath the washer. Cloth washer working fine.

Was this instruction helpful to you?

Customer:: amber from rochester, WA
Parts Used:: WPW10730972
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Socket set

the pump went out on the washer

took the old part out by the front panel and put the new pump in and now it works great. only took a couple of minute to put the new one in. thank you for saving my washer.

Was this instruction helpful to you?

Customer:: lou from stamford ct, CT
Parts Used:: WPW10110225
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

HF code durring cycle

Removed top of washer and replaced flow meter.

Was this instruction helpful to you?

Customer:: Anthony from Avon Lake, OH
Parts Used:: W10289554A
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Socket set

needed to install shipping bolts

Read the instructions provided by PartSelect.....and with a bit of patience I installed all four bolts so the washer's inside agitator was not damaged in shipping. I highly recommend that anyone who is moving/storing or shipping their washer that you find the correct shipping bolts according to your model and make and install them prior to moving your appliance.

Was this instruction helpful to you?

Customer:: Barbara from Hernando Beach, FL
Parts Used:: WPW10249845
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

F35 Error Code Suds

Watched a YouTube video, saw how simple it was. Did all the things the video said to do. Then it said that if the error code came back, by the part. I bought the part SUNDAY night and it was under my door mat Tuesday when I came home from work. Removed three screws, took off the top of the washer, plugged the electronics, shoved the little hose on, put the top back on and boom, no problems! Now, if I could just find a YouTube on a Fisher Paykel dishwasher, I'd be in business... Great part, reasonable price, great service, great shipping.

Was this instruction helpful to you?

All Instructions for the 11047701801