11015962401 Kenmore Washer - Parts

It connects from the pump to the back panel. The clamp is not included.

This spring is used on the leveling components in a washer. Please note, this spring may differ in appearance, but functions the same as original.

This part goes on the agitator retaining bolt.

This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers,...

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Sold Individually.

This part is the replacement lid seal for your washer. It is made of rubber and is gray in color. It is approximately 21 inches long and 1 inch wide. The washer lid seal creates a seal for your top lo...

This insert is sold individually. Knob not included. Knob is sold separately.

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shakin...

This is used in your direct drive washer that has a neutral drain.

This kit comes with the clamps.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.