11022032102 Kenmore Washer - Parts

This spring is used on the leveling components in a washer. Please note, this spring may differ in appearance, but functions the same as original.

This part goes on the agitator retaining bolt.

This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers,...

Sold Individually.

This part is the replacement lid seal for your washer. It is made of rubber and is gray in color. It is approximately 21 inches long and 1 inch wide. The washer lid seal creates a seal for your top lo...

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shakin...

This is used in your direct drive washer that has a neutral drain.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This hose clamp is sold individually.

This is a pack of three suspension pads for your washer. The suspension pads in your washer are found underneath the tub and prevent the rotating metal parts from grinding on one another. If your susp...

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...

This hose can handle hot or cold water and is five feet long.