11081351100 Kenmore Washer - Parts

It connects from the pump to the back panel. The clamp is not included.

This spring is used on the leveling components in a washer. Please note, this spring may differ in appearance, but functions the same as original.

This idler shaft retaining ring is well under an inch long and is made of metal.

Sold Individually.

This kit comes with the clamps.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the wa...

This kit comes with springs, hardware, and brake lining.

This seal is for the top of basket drive tube shaft.

This is the bearing for the lid hinge. Sold individually.