HAV4657AWW Hoover Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Erich from Sheffield Village, OH
- Parts Used:
- WP21002026
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Socket set, Wrench set
washing machine shakes and moves during spin cycle
Had no problems taking machine apart following online instructions. At first couldn't find snubber ring because it was completely worn away. Once found it was very easy to replace. Only problem with putting back together was getting the first spring back on, after that it was a breeze. Machine up and running.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donald from Rapid City, SD
- Parts Used:
- WP21352320, WP21001166, 12002773, WP21002026
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers, Socket set
washer danced around in spin cycle
I would not recommend trying this without the spring removal & re-install tool. Very difficult to impossible to remove the springs with pliers. Not meant for novice handy persons.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gina from Los Angeles, CA
- Parts Used:
- 35-6714, WP35-2044, 12002213, WP21002026
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Socket set
Won't Agitate, Won't Spin, Jumping around, squealing in spin cycle, abrupt stop
Washer was jumping around in the spin cycle to the point that it disengaged the water fill level hose which in turn caused it to overflow. I fixed the hose but almost immediateley it stopped spiining or agitating. I looked online to find that the jumping around was most likely the snubber ring ... the hard stop and squeal most likely the Brake Stator ... the no agitaion or spin was likeley the thrust bearing. I ordered the parts and were received in a couple of days ... by the time they came I had already torn apart everything and was just waiting on parts for reassembly. The instructions were concise and complete but I did benefit from watching a YouTube video on the repair. All the parts went together just like they were supposed to even with my limited mechanical skills. All I really used was a small socket set, a couple of screw drivers and a pair of pliers. Taking the Brake assembply is dangerous but can be done with no special tools if you buy a couple of 2 inch 10-24 screws to replace two of the short ones and then back them out slowly (look for a youtube video on this procedure EASY!) ... took me a couple of hours but any one who has used a screw driver more than once could probably do it in under an hour. Washer now running like new ... No Jumping!!! People at Parts Select were Great!!! BTW ... So that the springs would be easier to re-install, I stuck about $50 of quarteres between the coils before removing ... worked Great!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cheri from Crowley, TX
- Parts Used:
- WP21352320, WP21001950
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Motor hummed and did not operate.
1.Removed front panel to access the motor. 2.Tilted the washing machine onto it's back, in order to remove the belt. 3. Unpluged motor wiring and removed the old motor and mounting plate.
Was this instruction helpful to you?
Thank you for voting!