GMAN1200L1WW General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- LARRY from GREENWELL SPRINGS, LA
- Parts Used:
- WH41X10118
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Wrench set
Water dripping from soap dispenser outlet tube
Removed top cover, loosened front door cover, removed & replaced old cracked plastic 'water inlet tube', reinstalled front door unit & top cover. Very tight space to work in when not completely removing front door unit.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Wylie, TX
- Parts Used:
- WH07X10016
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set, Wrench (Adjustable)
Rattling during the spin cycle
After I disconnected the power and water and turned the washer around. I removed the back panel cover and the top and back panel to get to the pulley wheel. Once I remove the retaining nut and pulley the wheel off the spindle, i compared the new and the old parts and noticed the obvious wear on the old part, luckily the spindle was not damaged and still functional. Placing the new pulley wheel was a little more challenging. Once I seated the pulley wheel with a gentle tap from a rubber mallet. I fitted the lock nut onto the spindle and continued seating the wheel evenly using the nut to the prescribed torque pressure. After I reassembled the washer and reconnected the water and power, tested the washer, and success!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jimmy from Zebulon, GA
- Parts Used:
- WH41X10118
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers
Water leaking from the door boot area.
I watched the video and followed the instructions. First remove power. Remove the rear cover from the control panel and the top cover. Then remove screws that secure the control panel to the frame and remove the control panel. Remove the bottom cover. Then remove the lock ring that holds the rubber boot to the front panel. Remove the door and remove the water inlet pipe. Assemble the machine and run a test cycle.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Luciano from Houston, TX
- Parts Used:
- WH41X10118
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
The Washer Was Leaking A Lot Of Water
I saw the video on how to remove the boot seal, and I just follow the instructions. Replacing the water inlet pipe was easy.
Was this instruction helpful to you?
Thank you for voting!