53040116 General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Carolyn from Ormond Beach, FL
- Parts Used:
- WH1X2757
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Timer knob no longer worked
An older gentleman neighbor needed help finding a part for his machine. We checked local parts stores to no avail. I researched the internet, found your site and ordered the part. My adult son put the part on in less than 15 minutes. Our neighbor was very happy. We will tell any one in our neighborhood to order parts here. We followed the part watching UPS. The part arrived at the exact day and time. It couldn't be easier.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joshua from Cumberland Gap, TN
- Parts Used:
- WH1X2026
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Washer would no longer spin---dry rotten belt
Gently turned washer over onto its front. Removed bottom metal panel (3 or 4 screws on each side). Removed old belt. Installed new belt. NOTE: The new belt is a tight and perfect fit, therefore it will not want fit on to both pulleys/ rotating discs. I have found the best method is to start the belt on the disc that drives the belt. Then place as much of the belt over the disc that sits below the washing machine drum as is possible(the spinning part)and then turn the belt by hand and the belt should pop on to the disc. If the belt goes on easily you may have the wrong belt as the belt must be tight to achieve the traction necessary for the washing machine to spin. HOPE THIS HELPS!! A screwdriver may be handy in helping to pry on the belt. Good look.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharon from Mexico, MO
- Parts Used:
- WH1X2117
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
wouldnt turn to wash cycle was turning manulie
its great and saved me lots of money enjoy my washer again
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- dennis from mooresville, NC
- Parts Used:
- WH13X81
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
slow cold water
quck delivery thanks. removed back panel and valve assembly. replace unit,and replaced panel. yep it works
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Zhiyong from North Potomac, MD
- Parts Used:
- WH1X2026
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers, Wrench set
Washer can drain but not spin, buring smell
Lay the washer on its side, unscrew three screw to loose the rotor, put the belt and screw the rotor back.
Was this instruction helpful to you?
Thank you for voting!