58971K2WW General Electric Washer - Parts

This replacement inlet drain hose connects your washer's water pump to its tub. This hose is seven and a half inches in length and only two inches wide.

This is a water pressure switch hose, also known as the air dome tube, for your washer. It is made of clear plastic and is sold individually. The hose transports water to your water pressure switch, s...

This is the start/stop button for your washer. If your washer will not start after the button is depressed, you may need to replace it. However, you may also want to check your door switch, because wh...

This part is a replacement socket rod support for your washer. The socket rod support is found at the top of the washer frame in the front part of the washer. It supports the suspension rod, so the ro...

This screw is sold individually.

This part helps center and support the drum, transmission and motor assembly.

Restore your washer’s performance with this shaft and mode shifter assembly, which controls the transition between wash and spin cycles. It connects the motor to the wash plate and responds to signals...

This part is the replacement belt install tool for your dryer. It comes with two round plastic halves of the tool that are held together with an o-ring (also included). To use the tool, position the t...

This part is used to keep your tub upright and somewhat level during the different cycles.

Sold Individually.

Sold individually.