Models > 52750-4 > Instructions

52750-4 General Electric Washer - Instructions

Jump to:

All Instructions for the 52750-4

Customer:: Pauline from Kelseyville, CA
Parts Used:: 134101800
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Wouldn't rinse, spin, or pump out the water

Ordered the part online from PartSelect and it arrived Friday morning just 3 days later to my front door. Removed 2 screws, disconnected 2 wires, screwed the new part into place, plugged in the new wires and it still didn't work. Looks like my washer is just too old. So . . . I called PartSelect, explained everything. Three days later a full refund was in my bank account. Shop PartSelect with confidence. I will be back!

Was this instruction helpful to you?

Customer:: Carolyn from Orange beach, AL
Parts Used:: WE16X29397
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Old lint filter was bent and screen torn.

Ordered a new lint filter around 2 pm and received it UPS the following day. Popped it in and we're good to go. Could not have been faster or easier!

Was this instruction helpful to you?

Customer:: Joseph from Silver Spring, MD
Parts Used:: WE16X29397
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

filter was busted

Replaced

Was this instruction helpful to you?

Customer:: Gerald from Battle Creek, MI
Parts Used:: 5303937139
Difficulty Level:: A Bit Difficult
Total Repair Time:: 1- 2 hours
Tools:: Nutdriver, Screw drivers

Removing old felt and glue

After removing the old drum glide there was tufts of felt and glue left behind. The DIY video (which inspired me to try this repair myself) says to use a scraper and wire brush to clean the drum edge. I decided to try a drill with a wire wheel. Worked great. The surface was shining clean in minutes.

Was this instruction helpful to you?

Customer:: robertt from rio grande, NJ
Parts Used:: 134101800
Difficulty Level:: Really Easy
Total Repair Time:: 1- 2 hours
Tools:: Screw drivers

would not drain

followed on line instructons very easy

Was this instruction helpful to you?

Customer:: Pleshette from Hawthorne, CA
Parts Used:: 5303937139
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

Clothes were getting stuck between machine body and drying drum, also there was a squeeking and a noise that sounded as if something was clanking around, like a coin.

I watched the great easy to follow video from PartSelect. Absolutely nothing unclear. I was able to open the top and disconnect the front panel in less than 10 minutes! Removed the old felt drum glide, scraped off any stuck felt and loose glue. Then glued the new pad in place, using 3 small clamps, like clothes pins. Let it set for about 15 minutes then put it all back together! I did forget to reattach the ground wire, so I had to open the lid back up for that. About 50 minutes total. Also I took the opportunity of having the front panel off to give the inside a good vacuuming, not a ton of lint but enough to go ahead and clean it out! Thanks for the help!

Was this instruction helpful to you?

Customer:: James from Mitchell, SD
Parts Used:: WE03X29897
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

broken belt

Thanks to your great DYI video I completed the repair in less than 45 minutes very easy.

Was this instruction helpful to you?

Customer:: Tom from Aquone, NC
Parts Used:: WE03X29897
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

Dryer Belt Squealing

I followed the provided video precisely. Made the job quite easy. My only problem is I'm 6'2", 275 lbs. with bad knees. Can't go at it exactly as shown in the video because I can't squat down in front of the dryer without pain. Called in a neighbor of smaller stature for him to come from one side, and me from the other. Worked flawlessly. Video is excellent. I do recommend wearing gloves and/or long sleeve shirt. I cut up my arms a bit, but that could have been easily avoided.

Was this instruction helpful to you?

Customer:: Michael from Lucas, IA
Parts Used:: 5303937139
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Screw drivers, Socket set

clothes getting caught around drum leaving marks on them

took front off machine removing screws. Removed old felt and cleaned old glue off making sure area was clean. applied new glue and then new felt drum glide. put fish sringer around complete drum pulling tight clamping with vise grips till dry. then put front back on machine.

Was this instruction helpful to you?

All Instructions for the 52750-4