CWL2000R*119 General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- dennis from mooresville, NC
- Parts Used:
- WH13X81
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
slow cold water
quck delivery thanks. removed back panel and valve assembly. replace unit,and replaced panel. yep it works
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Wilbur, WA
- Parts Used:
- WH8X305
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
Water Leaking Onto Floor At The Let Front Corner
Using the 1" putty, push in on the 2 clips holding the top of the washer. Lift top, exposing the top of tub. Remove old rubber seal from top edge of tub. To ease installation of new seal, stretch it over the edge of tub which tensions it, then start tucking the outer lip along the outside edge, tilting the seal towards the outside edge until the seal is completely in its groove all around. I had to hold down on the seal to keep it from rolling off while I lowered the top back down. When the lid is down, push hard to engage the 2 clips that lock it down.
Was this instruction helpful to you?
Thank you for voting!