GFWH1405D0MP General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jonathan from Oviedo, FL
- Parts Used:
- WH13X10023
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
water would not stop filling in machine even when it was unplugged! !
Step 1- pull washer away from wall. Step2- unplug power, shut off water and disconnect lines, and disconnect drain line. Step 3- unscrew 3 screws from bk and 3 screws from behind control panel. Step 4- remove back of control panel and top of washer. Step 5- unplug wires from old valve and plug into new valve to avoid wrong connection take out screw from back releasing old valve , insert new valve and put back screw. Step 6 put top of washer and back of control panel on and insert screws. Step 7- reconnect hoses and drain , plug washer in and test. All done. I recommend adjusting to level if necessary at this point before pushing back against wall. Good luck. Hope this helps somebody. Jon
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RON from APPLE VALLY, MN
- Parts Used:
- WH13X10023
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Hot water hose leaking, it was cross treated (twice) by the installer, would not warranty it the second time.
Followed your instruction, very easy. I installed Camco 90" & 45" Brass elbows to relieve strain on hoses.
Was this instruction helpful to you?
Thank you for voting!