GTW460ASJ3WW General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Chris from LARGO, FL
- Parts Used:
- WH08X37938
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Lid was forced open and broke latch
Follow the super simple, precise instructions and it is very easy. Only harder part was unclipping the front of the lid.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeremy from JOHNSTOWN, NY
- Parts Used:
- WH01X24697
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Socket set
Washer not spinning out completely.
1) Unplug washer
2) Remove water supply hoses
3) Remove drain hose
4) Tilt washer forward
5) Remove 4 bolts covering the motor assembly to access belt.
6) Remove old belt by turning it off the pullies.
7) The new belt needed to be stretched by attaching one end of the belt to one of the pullies using a zip tie. I did this by drilling a small hole in the larger pulley, large enough to allow the zip tie to pass through.
8) After tightening the zip tie to the belt, slowly turn the larger pulley to stretch the belt on to the smaller pulley.
9) Make sure belt is properly seated on both pullies.
10) Reinstall the cover.
11) Reattach drain hose and supply hoses.
12) Plug washer back in.
2) Remove water supply hoses
3) Remove drain hose
4) Tilt washer forward
5) Remove 4 bolts covering the motor assembly to access belt.
6) Remove old belt by turning it off the pullies.
7) The new belt needed to be stretched by attaching one end of the belt to one of the pullies using a zip tie. I did this by drilling a small hole in the larger pulley, large enough to allow the zip tie to pass through.
8) After tightening the zip tie to the belt, slowly turn the larger pulley to stretch the belt on to the smaller pulley.
9) Make sure belt is properly seated on both pullies.
10) Reinstall the cover.
11) Reattach drain hose and supply hoses.
12) Plug washer back in.
Was this instruction helpful to you?
Thank you for voting!