WCRE6270DCCC General Electric Washer - Parts

This screw is sold individually.

This part helps center and support the drum, transmission and motor assembly.

Restore your washer’s performance with this shaft and mode shifter assembly, which controls the transition between wash and spin cycles. It connects the motor to the wash plate and responds to signals...

This part is the replacement belt install tool for your dryer. It comes with two round plastic halves of the tool that are held together with an o-ring (also included). To use the tool, position the t...

Sold individually.

This cover goes on top of the balance ring that is located on top of the basket.

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

This part holds the water during the wash cycle and houses the spin basket.

In the spin cycle the drive motor rotates the spin basket. When its in the agitation cycle it turns the gearcase shaft. Note: Please unplug the washer before installation.

Sold individually.

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside t...