GTAN4250M1WS General Electric Washer - Parts

This is the start/stop button for your washer. If your washer will not start after the button is depressed, you may need to replace it. However, you may also want to check your door switch, because wh...

This part is a replacement socket rod support for your washer. The socket rod support is found at the top of the washer frame in the front part of the washer. It supports the suspension rod, so the ro...

This screw is sold individually.

This part helps center and support the drum, transmission and motor assembly.

This is a replacement screw for your washer. The screw has a hex head and is approximately 1 inch in length. The washer portion of this screw is approximately 1 inch in diameter. This part is sold ind...

The triple water valve or inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your washing machine continues t...

Restore your washer’s performance with this shaft and mode shifter assembly, which controls the transition between wash and spin cycles. It connects the motor to the wash plate and responds to signals...

This part is used to keep your tub upright and somewhat level during the different cycles.

Sold individually.

This cover goes on top of the balance ring that is located on top of the basket.

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

This part is the replacement pressure switch, also known as the water-level pressure switch, for your washer. It is round and red on one side, and white with gold terminals on the other. The pressure ...