WDSR2080DECC General Electric Washer - Parts

This screw is sold individually.

This is a replacement screw for your washer. The screw has a hex head and is approximately 1 inch in length. The washer portion of this screw is approximately 1 inch in diameter. This part is sold ind...

This part does not include the agitator cap. Must order separately.

This part is able to sense the water level in the tub. When the water reaches the desired level, this switch stops the water from flowing in the tub and then the washing program begins.

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known...

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

This part increases the voltage to the drive motor to help start it.

This transmission and brake assembly comes with a new tub seal. This kit aids in the spinning or agitating cycles.

Sold individually.

This cover goes on top of the balance ring that is located on top of the basket.

Sold individually.

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.