GJRR4170H3WW General Electric Washer - Parts

The tub bearing secures the spin basket in the tub assembly of a washer. It is located on the bottom of the outer tub. A common symptom of a worn tub bearing is a very loud noise (including a grinding...

Bolt not included. This part connects the transmission drive shaft to the agitator base.

Used in conjunction with the timer dial knob assembly.

The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.

This replacement inlet drain hose connects your washer's water pump to its tub. This hose is seven and a half inches in length and only two inches wide.

This part is a replacement fabric softener dispenser for your washer. If your washer will not dispense fabric softener or detergent, or will not agitate, you may need to replace the dispenser. When it...

This part is a replacement socket rod support for your washer. The socket rod support is found at the top of the washer frame in the front part of the washer. It supports the suspension rod, so the ro...

This screw is sold individually.

This part helps center and support the drum, transmission and motor assembly.

This is a replacement screw for your washer. The screw has a hex head and is approximately 1 inch in length. The washer portion of this screw is approximately 1 inch in diameter. This part is sold ind...

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known...