WMXR3080T5WW General Electric Washer - Instructions

Took off the broken ones and pushed on the new ones. Simple, simple

I just pulled the old part out using no tools with minimum pressure and pushed the new dryer knob in with no problems at all within approximately 10 seconds.

Removed control panel. Knob was difficult to remove and a wrench was used to remove. Connecting the wires to the new timer was easy

I work in hvac, I more or less understand the older electro mechanical non electronic machines so I gave diagnosis a stab. I already knew that the water level switch could cause problems. I noted that the hot and cold water fill valve solenoids DID shut off tightly. While testing, I tried blowing and sucking on switch hose port and listened for a clear click; no click. At this point you replace the switch just to be sure. I blew out on outlet side of vinyl tubing going into water in tub. Used model and serial number to locate part on website. I physically removed water level switch (you twist it off by gently prying under a tab and turning 90 degrees) or else remove switch with short mini philips. I very carefully compared the removed switch visually to the very good multiple multi position photos on website. That showed me that the switches looked the same. So when I orderred the part I was 98% sure it was right. The part arrived and was correct. I installed it in 5 minutes, tested it with different levels. Machine repaired! Recorded part number in computer notes.

I used a pair of pliers to turn my dryer on until I broke the center part where the knob went. I order the part that was in the dryer first and it came the next day. When it got here I realized I still needed the knob. It came the next day also. It took my handyman about 15 minutes to replace both and he also cleaned out all of the missing socks and other items behind my dryer. Good Job!

It was only a matter of putting a new knob in place of the broken one. No tools required.

Knob stem was split, leaving the metal bushing on the dryer's Start switch. Used pliers to remove metal collet. Aligned new knob to switch, and firmly pushed replacement part into place. Tested results and found it to be satisfactory.

I was going to buy a new washer and dryer, then the opportunity came up to buy the house instead, so I opted for the repair. It was very simple. I had four small torx bolts to get to the control panel, a small screw that i took out with a nutdriver to take the timer out and a phillips head screw driver to loosen the ground. It was simple and quick, and very cheap, considering my options.