EWA3000B0WW General Electric Washer - Parts

This part is a replacement fabric softener dispenser for your washer. If your washer will not dispense fabric softener or detergent, or will not agitate, you may need to replace the dispenser. When it...

This is the start/stop button for your washer. If your washer will not start after the button is depressed, you may need to replace it. However, you may also want to check your door switch, because wh...

This part is a replacement socket rod support for your washer. The socket rod support is found at the top of the washer frame in the front part of the washer. It supports the suspension rod, so the ro...

This part is the replacement inner tub base hub for your washer. It is made of metal and is approximately 15 inches in diameter. The inner tub base hub fits between the wash tub and the spin basket, a...

This screw is sold individually.

This retaining clip is a spring clip that should be replaced each time it is removed from the clutch assembly.

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known...

This part is used with units that have a removable front panel.

This transmission and brake assembly comes with a new tub seal. This kit aids in the spinning or agitating cycles.

Sold individually.

This cover goes on top of the balance ring that is located on top of the basket.

This kit comes with two butt connectors.