WCSR4170D5CC General Electric Washer - Parts

This screw is sold individually.

This is a replacement screw for your washer. The screw has a hex head and is approximately 1 inch in length. The washer portion of this screw is approximately 1 inch in diameter. This part is sold ind...

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known...

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

This part increases the voltage to the drive motor to help start it.

This transmission and brake assembly comes with a new tub seal. This kit aids in the spinning or agitating cycles.

Sold individually.

This cover goes on top of the balance ring that is located on top of the basket.

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside t...

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

This part holds the water during the wash cycle and houses the spin basket.