WBLR2040VAA General Electric Washer - Parts

If your washer is leaking when it is filling or agitating, you may need to replace the tub seal. The tub seal is found between the transmission and the outer tub in your washing machine. This genuine ...

This split ring is two inches in diameter.

Also known as a Rotary Switch. This part regulates the temperature of the water in the tub.

This compression ring works in conjunction with the timer dial.

This part is the replacement inner tub base hub for your washer. It is made of metal and is approximately 15 inches in diameter. The inner tub base hub fits between the wash tub and the spin basket, a...

This retaining clip is a spring clip that should be replaced each time it is removed from the clutch assembly.

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

This transmission and brake assembly comes with a new tub seal. This kit aids in the spinning or agitating cycles.

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

The motor included in this assembly performs 1640 revolutions per minute in one speed, and 1050 revolutions per minute in the other speed. It runs at 1/2 horsepower and carries 115 volts. The capacito...