WJSR2080T8WB General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Mahlon from Northville, NY
- Parts Used:
- WH45X10027
- Difficulty Level:
- Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers, Socket set, Wrench (Adjustable), Wrench set
Base hub had broken into several pieces.
The repair was done as describe by others with the "hub nut" having to be cut off due to corrosion. Instructions for removal of the tub were found inside the control panel area on the left hand side. Ordering s new hub nut and cutting off the old one proved to be a necessity.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Olle J from Albert Lea, MN
- Parts Used:
- WH2X1197
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers
Noisy washer, especially while spinning.
Take off front. Take off top. Pull off agitator. Pull off agitator coupler, after removing bolt holding in place. Attempt to remove hub nut, no joy. Wound up cutting the nut with a Dremel tool and chiseling the nut off. Closer inspection revealed a bad transmission. Due to the cost of the transmission, we will continue to use the machine until it completely fails.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jon from Merriam, KS
- Parts Used:
- WH12X1022
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
Washer would not complete the cylcle, it stop in the middle
I was going to buy a new washer and dryer, then the opportunity came up to buy the house instead, so I opted for the repair. It was very simple. I had four small torx bolts to get to the control panel, a small screw that i took out with a nutdriver to take the timer out and a phillips head screw driver to loosen the ground. It was simple and quick, and very cheap, considering my options.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marlene from Sutter Creek, CA
- Parts Used:
- WH12X1022
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Wrench (Adjustable)
.Unable to use machine because selection knob was loose.
Removed control panel. Knob was difficult to remove and a wrench was used to remove. Connecting the wires to the new timer was easy
Was this instruction helpful to you?
Thank you for voting!