WLSE3150A0AA General Electric Washer - Parts

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

This part holds the water during the wash cycle and houses the spin basket.

This screw is sold individually. Size: 14-10 a trt 7/8 s.

Sold individually.

This part is for the hose to outer tub.

This funnels the bleach in to your wash.

This part is located behind the control panel. It controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences. Reuse the jumper wire from old board.

The motor included in this assembly performs 1640 revolutions per minute in one speed, and 1050 revolutions per minute in the other speed. It runs at 1/2 horsepower and carries 115 volts. The capacito...

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside t...