FWS1233AS0 Frigidaire Washer - Instructions

Put the knob on and done!

removed broken knob..pushed new knob on..

Just slipped it on the on-off control, gave it a twist and it was done! Fit perfectly. So glad I found your site.

i took the old knob off and put the new one on. it took about 10 seconds. it was simple.the service dept. was extremely helpful in getting the right knob. it was delivered the very next day. i would definitly recommend this company to anyone who has a parts problem.....

no problem, pushed the new knob on and all worked as it should.

Really liked how easy it was to identify the part on your website, thank you.
Opened the package, pushed on the knob. FIXED! YEA, no more pliers!

Just put the the new one on. Parts select was easy to order and fast delivery thanks again.If I ever need a part i will be sure to come back to your site. Thanks so much... Mike Brooks

After receiving the part, I easily replaced it. I didn't need any tools and it took less than 2 minutes to fix. Also, the dryer seems to be working better altogether. Basically, I just inserted the knob where it was before.

Took broken knobs off and replaced with new ones. Only one fit snuggly; the other two are raised and wobbly.

I received the Dryer knob in the mail the next day. All I had to do was slip it on. Very easy installation.

Just push the new knobs on slot. Very simple process. The best part is that it was relatively cheap and the shippping to my home was fast. Thanks.

Pulled out the machine. Disconnected water lines. Removed four screws attaching the top brackets. In rear of top panel. Slid top panel forward and clear of valve. Removed two wire harnesses. Removed two screws holding valve to the back panel. Pulled valve down and out. Removed outlet side line spring clamp with channel lock pliers and pulled hose off old valve. Installed outlet side hose and spring clamp onto new valve. Placed valve up into place and installed two screws. Installed two wiring harnesses. Replaced top lid. Replaced lid bracket screws. Re-attached water hoses and pushed the machine back into place.

No tools was required. Last month the knob broke on my washer. I done a Google search and parts select came up. I felt comfortable ordering online from them because of their reputation. I got the part faster than I expected....my wife was happy too!

Removed two screws that held top of washer in place. removed top of washer. Removed two screws that held water inlet alve in place. Removed clamp and outlet hose from old inlet valve.












































































Removed two screws hold wash machine cover in place. Removed cover. Unscrewed cold and hot water supply lines from old inlet valve. Removed two screws holding inlet valve in place. Removed clamp and hose from inlet outlet hose. Replaced inew inlet in reverse order.

Shut off water to washer....unplug power cord...pulled washer from wall out into room....removed 2 water supply hoses....removed 2 top retaining clip screws on rear top of cabinet.....lifted rear end of top panel up approx 5 inches......propped up with small pieces of cut up 2X4 lumber.....did not disconnect any wiring related to the control panel...remove 2 screws holding valve to cabinet back panel......lift valve up and out of cabinet by the tub fiil hose.....disconnect 2 wire plugs, mark these upper, lower or hot /cold......disconnect the tub fill hose....remove the back panel-to-valve bracket off the old valve and install on the new valve and reverse this procedure!!! The new valve flows water better and faster, the wash is done quicker!!