MFW126BZKS0 Frigidaire Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Robert from Daytona Beach, FL
- Parts Used:
- 134051003
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Simple and easy
Took the back off and installed the belt tight but ezsy to do
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Amistad St from Atlanta, GA
- Parts Used:
- 131763302
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
missing a piece on the door
Thank you.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dallas from Takoma Park, MD
- Parts Used:
- 131763302
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Broken door strike leading to broken door lock and switch assembly
Replacing the door strike is very easy. Two screws. The broken pieces stay in the door lock/switch assembly. The first time I got them out with needle nose pliers. A year later it happened again and this time I had to replace the lock/switch assembly. I followed procedure others mention here: Two screws at back of washer release the top. Slide that back. Then undo the two screws in the front of the assembly and lift it out, and replace. The important thing is that the door on the washer no longer aligns with the door lock/switch assembly, so we have to carefully (!) lift it to shut it. Do not slam. The issue with the door arises because instructions say to keep the door open so that mold does not grow in the basin. But the hinge on the door is not strong enough to support the door as it stands open when at rest over the years and it has begun to give way. This washer needs a new and stronger hinge. Meanwhile, do not slam your door. Shut it gently, lift if necessary, even on a new machine!
Was this instruction helpful to you?
Thank you for voting!
Replaced the bolt at the center of the belt pulley and replaced the belt
Note on my Easy rating- I had to replace the belt a few years ago and it was tough to get it on the pulley. This time it went quickly. Unplug, remove back plate. Replaced stripped out pulley bolt which had become loose. Could not find a torque value. Placed belt on motor and worked it around the pulley with a regular screwdriver to keep it from slipping off. No problem, but last time I changed the belt I used vice grips to lightly hold the belt to the pulley while walking the pulley around with two screwdrivers leveraged against the tub. While I was working I discovered that both of the tub shock absorbers were broken. Parts on order.
Was this instruction helpful to you?
Thank you for voting!