WFMC3301UC (09) Bosch Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Donald from CLARKSVILLE, TN
- Parts Used:
- 00436440
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
Water pump cracked
Look up how to repair on you tube. Removed control panel door and front panel as shown to expose water pump. Removed both hose. Showed how to release water pump from under machine ( I use vibrating cutter to cut rubber feet that held in place) this was much easier than way shown in video. Caution when putting hose clamp Bach on make sure it is all the way on. If not you will have water leak drain hose come off. But panels on . Be careful not to damage door lock 124 dollars if you do. Over all very easy to replace
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Claudia from IDLEDALE, CO
- Parts Used:
- 00436440
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
washer not draining
we watched a thorough you tube video which described each step and showed it being done, he made it look pretty easy but unforeseen elements such as rust etc took time but not obscenely so, just keep screws from each step separate and it's difficult just takes patience and a little time to get to the actual part, in fact that is the easy part taking it out and replacing it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from WOODLAND PARK, CO
- Parts Used:
- 00422244
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
The old Cold water inlet valve was leaking
I followed the video and it was an easy repair. I took my time and it was an incredibly simple repair. The new part fit perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mike from gothenburg, NE
- Parts Used:
- 00436440
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Drain pump quit working
Took small door off front of machine pulled pump and unhooked wires. Hooked wires back up to new pump and installed
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- KEVIN from FORT MYERS, FL
- Parts Used:
- 00436440
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
washer would not drain
Took off top and back panels. Secured tub. Laid on side. Removed old pump. Cleaned up excess water with shopvac. Installed new pump. Tilt upright. Remove material used to secure tub. Reinstalled panels. Unplug everything before repair and use gloves. I cut up my hands on the panel to access pump.
Was this instruction helpful to you?
Thank you for voting!