ALW210RMC Amana Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- John from Eagle River, WI
- Parts Used:
- R0131578
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
cold water would not shut off
thought wire between hot and cold valve was to short but after many phone calls found out valve could be ajusted by prying carefully up clips and moving valve closer not in directions
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- craig from wadena, MN
- Parts Used:
- WP40045001
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
broken idler pulley
knife to losen top, remove rear tabs securing top, unplug electical from timer and switches, unplug front door wiring, 2 bolts remove front, lift front pannel to remove. tape belt on drum on top. under drum you can see the belt around worn pulley. lift idler pulley assembly, remove belt from pulley, snap ring holds pulley in place remove woren pulley, install new, replace snap ring, restring belt. remove tape. spin drum to assure alignment. reassemble.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Asotin, WA
- Parts Used:
- WP40045001
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Socket set
Idler pulley bad, needs replaced
Repair went well using posted instructions. My advice is always replace pump as you will damage seal when pulling pump off shaft.
Was this instruction helpful to you?
Thank you for voting!