P75751-2W Amana Washer - Instructions

I'm not a professional repair person, so diagnosis was more difficult than this repair was. A little research online and some smart investigation(and by smart I mean unplugging the washer before taking the access panel off); resulted in a less than $30 repair - compared to what would have been close to a $150 technicians visit and repair! Simply unplug the washer, unscrew the access panel, unscrew the lid check switch, screw in the new switch, put the panel back on, plug the washer in, and start the wash cycle. Seriously, less than 15 minutes!

Correctly diagnosed that it was the lid check switch that wasn't working. Ordered the part and when it came it took 5 minutes to change out. Very easy and works fine.

After troubleshooting the drain system and my plumbing, I read online that it could be the open door switch. Part select agreed and I ordered the part. Their handy troubleshooting guide was helpful. The part came a few days later, and I easily replaced it. Has been working for two weeks and running.

Iam waiting to install it.when it stop again/it will take me about 5 min.

I took the back off the control panel marked placement of old switch with a sharpie marker removed screws and wires installed on new switch screwed down new switch on my marks replaced back now it is working good as new around 10 minutes total time

This website is GREAT! I found the part by looking up the symptoms, and once on the page for the lid repair switch, I found several folks with the exact same problem. This was such an easy fix. I waited for the part to come in, and once I had it in my hands, simply unplugged the machine, took out the 4 screws holding the control panel in place, and then took out the 1 screw holding the lid switch in place and replace it! It was really that simple! The machine works perfectly again. Worth every penny! One thing, the old part is black, and the new one is white, so it takes a moment to find it.

Tried replacing timer, mixing valve, drain pump to no avail. Bought the lid switch assembly. That worked, here's how to do it. Unplug washer. Remove two philips head screws on top control panel to remove front. The lid switch assembly is mounted on the back behind the timer, and easily recognizable by the fuse. Remove wires (I needed wd40 for this part) from old assembly and connect to new assembly. Use nut driver to remove nut that holds the assembly to the washer, being careful to note exactly where the assembly was mounted, because it's adjustable. Bolt new assembly in place. Replace control panel cover (be sure that the bottom lip fits inside before replacing the screws on top. Plug in washer. Turn on washer. You're done.

The 4 countersunk phillips head screws that retain the control panel were removed allowing access to the lid switch assembly. I took a picture of the switch assembly to record wire location with my phone. The one screw that retains the switch assembly was removed after all of it's associated wires were removed. The old switch was removed and the new switch installed. Problem solved.