LT7000XTF0 Whirlpool Washer Dryer Combo - Parts

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over ...

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shakin...

Metallic screw that is less than an inch long. Does not include the plastic washer.

This is used in your direct drive washer that has a neutral drain.

This kit comes with the clamps.

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This hose clamp is sold individually.

This is the cap for your agitator.

This is a pack of three suspension pads for your washer. The suspension pads in your washer are found underneath the tub and prevent the rotating metal parts from grinding on one another. If your susp...

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...

Sold Individually.