LTE5243DZ2 Whirlpool Washer Dryer Combo - Parts

This is used in your direct drive washer that has a neutral drain.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This hose clamp is sold individually.

This is the cap for your agitator.

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...

This part is used to activate the lid switch when the lid opens/closes.

This part is a one time use thermal fuse cannot be re-set and must be replaced when continuity between the pins is no longer present.

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

This kit comes with springs, hardware, and brake lining.

The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.

This seal is for the top of basket drive tube shaft.

This is the bearing for the lid hinge. Sold individually.