MUE2000AZW Maytag Washer Dryer Combo - Parts

This arm is what attaches to the idler pulley wheel. The grommet no longer comes with the part as it has been updated by the manufacturer.

This OEM lip seal kit helps prevent water leaks around the spinner shaft in front-load washers. It includes seals, grease, an O-ring, a tool, and a washer kit, and fits select Whirlpool, Maytag, and K...

This idler shaft retaining ring is well under an inch long and is made of metal.

This foot pad is just over an inch in diameter. It is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers.

This timer knob insert cap is just over two inches in diameter. It is all white in color and is made of plastic.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This kit contains a flat drive belt, two motor isolators, and an instructions sheet. The drive belt is made to slip on the pulley until the basket gets up the desired speed.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.

This hose clamp is sold individually.

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperatu...

This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.