MLE19PNAYW Maytag Washer Dryer Combo - Parts

This kit contains a flat drive belt, two motor isolators, and an instructions sheet. The drive belt is made to slip on the pulley until the basket gets up the desired speed.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.

This hose clamp is sold individually.

This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches around 183 degrees Fahrenheit, and will not cut in again. Like a house fus...

This thermal fuse is mounted on either the heating element or burner tube housing.

This terminal block assembly does not come with any hardware. It it three inches long and made of plastic and metal.

Sold Individually.

This male door strike is just under an inch long. It is made of metal.

This hose can handle hot or cold water and is five feet long.