LSE7800AEW Maytag Washer Dryer Combo - Parts

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This kit is used on 2-belt washers. It is recommended to change the seal kit at the same time.

This idler shaft retaining ring is well under an inch long and is made of metal.

This foot pad is just over an inch in diameter. It is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

Sold Individually. This adjustable leveling leg comes with a stop nut.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines.

This hose connects the outer tub to the pump of your washing machine. It is twelve inches long and all black in color. This hose is made entirely of rubber.

This hose clamp is sold individually.

This damper pad kit is used for base support. It comes with three six inch damper pads, two little tubes of lubricant. NOTE: This part will need adhesive to stick it in place.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.