41799802990 Kenmore Washer Dryer Combo - Parts

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing

The two-terminal high limit thermostat has a limit of 260 degrees Fahrenheit and acts as a safety mechanism that keeps the dryer from overheating. The thermostat will cut out when the internal dryer t...

"Male" piece of a dryer door closing mechanism.

This dryer heating assembly has 5/16" terminal on the housing.

This screw-in plastic leveling leg supports the washing machine. If your washer loses balance while it is tumbling, or makes loud noises, then it is best to replace the leveling leg to make sure the h...

This seal helps prevent any leaking around the transmission of washing machines.

This screw is designed to fit washers and dryers. Refer to the diagram provided by the manufacturer for further installation instructions and accurate application of screw in your tool.

This part comes with a ninety degree elbow.

This idler arm assembly comes with the pulley wheel.

This is a screw and it is used with a variety of home appliances. It is less than 1/2 an inch long, and is #8-18 x 3/8. This part is a pan head, sheet metal, screw. It is made of metal.

This start switch is a manufacturer-approved replacement part for your dryer. A faulty start switch means your dryer will not begin its drying cycle. In order to complete this repair, you will need a ...

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).