41761733811 Kenmore Washer Dryer Combo - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Randy from New London, NC
- Parts Used:
- 5303281153
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
Dryer was making a noise like scraching a black board.
The repair went very well.The biggest problem was the spring on the tension roller when putting back together.But it just takes a little bit of patients and it was fine.Works great now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dwight from Milaca, MN
- Parts Used:
- 5303281153
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers
replace rear bearing
This was a stacked washer and dryer combo and is a lot more difficult to repair, requiring a lot more to take apart and put back together.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Hiawassee, GA
- Parts Used:
- 5303937183, 5303937182
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
brown stains on clothes
-remove screws on top of dryer -check for clips on side -remove panel under control panel -remove screws (6) I think, holding control panel -disconnect door switch connector -remove 2 more screws holding front -you may have to lift the tub to allow the vent tube to clear for front removal - - Proceed with felt seal portion of repair - - - -GOOD LUCK You may need help.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Portsmouth, NH
- Parts Used:
- 5304516871
- Difficulty Level:
- Really Easy
- Total Repair Time:
- More than 2 hours
Filter Was Mangled
Took the old one out, put the new one in! (:>}
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mary from Clio, MI
- Parts Used:
- 5304516871
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
screen pulled apart
Pit a new filter in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Susan from Franklin, WI
- Parts Used:
- 5304516871
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Screen on filter bent and pulled away from frame
Took it out of the shipping box and popped it into the dryer.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Amy from salem, OR
- Parts Used:
- 5303281153, 5303281153
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
The Rear drum bearing kit had sheared off
Exactly how the video showed! It was super easy and I am a girl...although I am a lil more mechanicly inclined than most girls, it was a piece of cake!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Paragould, AR
- Parts Used:
- 5303937183, 5303937182
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
garment damage
Followed your very helpful video instructions. Saved me a ton. Five stars!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gerry from Asheville, NC
- Parts Used:
- 5304516871
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
lint basket was destrpyed
Really ,no repair;just put new lint basket in dryer;took seconds.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph R from Moorestown, NJ
- Parts Used:
- 5304516871
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Lint filter wore out
Ordered a new part and installed it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Alto, TX
- Parts Used:
- 137513300
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
There were several pieces broken around the band and as the drum turned, clothes would catch the cuts and slice right though like a razor blade
Take the top off the dryer. Once it's off, start inserting the bands from the inside. From the top or inside, control and move the drum as needed to insert band in place. Once band is in place, and holes line up, press down till you hear it snap in place. Repeat process with second band.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Ringgold, GA
- Parts Used:
- 5303281153
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Socket set
Really Loud Squeeking Sound
I watched the videos on this excellent website first. Then the repair was a breeze.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from Maple Shade, NJ
- Parts Used:
- 137513300
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
My dryers was making a loud thumping sound. Like it was off balance.
I Took the front off and saw the cushion was gone around the drum and glids were worn down. I ordered both parts . It took 5 minutes to glue the cushion back on around the drum and 2 minutes to snap the drum glids on.But what I couldnt believe was the amount of lint that was all over the inside of the dryer.I would suggest to anyone to take the dryer front off once a year and clean it all out . I now understand fully why there are dryer fires.But the fix was cake and it runs like new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rebeca from Burlingame, CA
- Parts Used:
- 5304516871
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Lint trap was broken
Replaced the lint trap
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from San Francisco, CA
- Parts Used:
- 131789400
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
old handle wouldn't stay in it's opening, kept falling off
snapped new handle in place
Was this instruction helpful to you?
Thank you for voting!