Models > FFLG3911QW0 > Instructions

FFLG3911QW0 Frigidaire Washer Dryer Combo - Instructions

Jump to:

All Instructions for the FFLG3911QW0
91 - 105 of 331
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
chris from dallas, TX
Parts Used:
131658800
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Latch on dryer no longer worked
So easy! I ordered the part on the website. Received it 24 hours later. And popped it in place. Good as new.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
william from hackettstown, NJ
Parts Used:
5303937182, 5303281153, 137513300, 131825900
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Very loud squeaking
Opened top, removed front cover, removed belt, took out drum, replaced bearing on drum and bearing guide on back of dryer. Reinstalled drum and belt, then replaced drum glides and upper felt,let glue set with clamps over night.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from Baltimore, MD
Parts Used:
134587700
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
E66 Error code, Door Open. Dryer shuts off on high temperature
Unplugged dryer. Removed top panel (2 screws top back of dryer). Removed control panel ( Unplugged from control board and 2 screws) Removed front panel with door ( Unplugged light from control board, door switch at connector, and 4 screws) Removed Control Thermister from dryer exhaust blower housing located bottom front of dryer ( Unplugged 2 wires and removed 2 screws ) Installed new Control Thermister and replaced all screws and panels in reverse order. Note: Noticed connector for door switch seemed a little loose when connected correctly. Used electrical tape to reinforce connection. Plugged dryer back in and checked operation. Dryer has been used approximately 10 times since repair with no issues.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
MIKE from MASSAPEQUA PARK, NY
Parts Used:
131825900, 131724301, 131205400
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Wrench set
dryer was squealing loadly
took off face of dryer, removed drum 4 screws removed two srews holding bearing and shaft ,replaced shaft bearing and shaft . Just for preventive maintenance i replaced idleling arm and dryer belt. I lined everything up replaced drum used shop vac to clean lint and dust from all parts replaced face of dryer and boom i got a btand new dryer
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Eileen from SHERIDAN, CA
Parts Used:
137513300
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Glide was broken
I watched the video on the repair and followed it. Super easy. Repair only took 30 mins. Please note there are 2 glides. Make sure to order 2.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from PORT CLINTON, OH
Parts Used:
5303281153
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Squeaking
Watched Video Provided. Very Simple Repair. Asked my lovely wife to hold drum in place while replacing drive belt. She gladly complied and is back doing what she seems to love most. And no, I'm not kidding. Our washer and dryer seem to run 24/7/365. I've completed various repairs on both appliances over the last couple of years and saved 100's of dollars thanks to this site .
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
April from CARYVILLE, TN
Parts Used:
5303281153
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Noisy
Took it apart and installed the parts. Then I threw the dryer in the trash and bought a new one.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Debra from BROOKLYN, NY
Parts Used:
131658800
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Just popped the part I ordered right in and it's was closing in no time !
Just opened package and popped the part right in!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Allan D from REDLANDS, CA
Parts Used:
137551901
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
the attached anchors and holes linled up about 80% of the time.
I cut off the four that didn't line up - I suppose since this was a gasket that fit several makes, I should expect this type of problem.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rick from CHICAGO, IL
Parts Used:
5304500453
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Mother board for dryer did not work
The part was on back order for two months. When Partselect notified me that the part was on its way it arrived in three days. Then I installed the board to the dryer and connected all the proper wiring together and the dryer was back to working normal again. Thank you Partselect. Rick C
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
james from tahlequah, OK
Parts Used:
5303281153
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
bearing went out
took apart and replaced parts easy to do but no one in my town can get me parts. thay want 100.00 gust to come out and look at it so found parts online and thats that
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
GERALD from HARRISONBURG, VA
Parts Used:
137576600
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
old plug would not stay in.
removed old plug which snap out very easy and
snap in new plug.
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Omar from Rumford, ME
Parts Used:
5304516871
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Damaged Filter
Took out the damaged lint filter and replaced with new one.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Linda from Batesburg, SC
Parts Used:
5303207102
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
strike broken
popped in one in
7 of 19 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ANGEL from MIAMI, FL
Parts Used:
5304516871
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
LINT FILTER
JUST DROP IT IN WOOOOLA
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FFLG3911QW0
91 - 105 of 331