FLGB8200FS3 Frigidaire Washer Dryer Combo - Parts

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing

Sold individually .This knob accepts a D-shaped shaft.

"Male" piece of a dryer door closing mechanism.

The upper felt seal for your dryer is attached to the top edge of the drum support area, and is held there by a high temperature adhesive. It creates a seal where the dryer door opens and closes, so t...

This screw-in plastic leveling leg supports the washing machine. If your washer loses balance while it is tumbling, or makes loud noises, then it is best to replace the leveling leg to make sure the h...

This seal helps prevent any leaking around the transmission of washing machines.

This screw is designed to fit washers and dryers. Refer to the diagram provided by the manufacturer for further installation instructions and accurate application of screw in your tool.

This idler arm assembly comes with the pulley wheel.

This is a screw and it is used with a variety of home appliances. It is less than 1/2 an inch long, and is #8-18 x 3/8. This part is a pan head, sheet metal, screw. It is made of metal.

This start switch is a manufacturer-approved replacement part for your dryer. A faulty start switch means your dryer will not begin its drying cycle. In order to complete this repair, you will need a ...

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

This part senses the flame for heat allowing the gas valve to open.