FLSG60RGS1 Frigidaire Washer Dryer Combo - Parts

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing

"Male" piece of a dryer door closing mechanism.

The upper felt seal for your dryer is attached to the top edge of the drum support area, and is held there by a high temperature adhesive. It creates a seal where the dryer door opens and closes, so t...

This screw-in plastic leveling leg supports the washing machine. If your washer loses balance while it is tumbling, or makes loud noises, then it is best to replace the leveling leg to make sure the h...

This knob accepts a D-shaped shaft.

This seal helps prevent any leaking around the transmission of washing machines.

This screw is designed to fit washers and dryers. Refer to the diagram provided by the manufacturer for further installation instructions and accurate application of screw in your tool.

This idler arm assembly comes with the pulley wheel.

This is a screw and it is used with a variety of home appliances. It is less than 1/2 an inch long, and is #8-18 x 3/8. This part is a pan head, sheet metal, screw. It is made of metal.

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

This part senses the flame for heat allowing the gas valve to open.

This idler pulley assembly is a manufacturer-approved replacement part for your washer/dryer. The assembly includes the idler pulley and arm. The idler pulley provides tension for the belt to rotate t...