Models > W123-C > Instructions

W123-C Jenn-Air Wall Oven - Instructions

Jump to:

All Instructions for the W123-C
31 - 37 of 37
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Romeo from Suffolk, VA
Parts Used:
WPY703499, WP703502
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
two from knobs were so old from constant washing you could not see the lettering on the knobs.
pulled one off and pushed the other one on.fino
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mark from Niagara falls, NY
Parts Used:
WPY703499, WP703502
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Old knobs worn out
The new knobs were simply pressed in placed on the existing shaft, perfect fit, looks just like new, yet 24 years old. Would tell family and friends to shop for parts at Part Select.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Vern from Sugar Land, TX
Parts Used:
WP701650
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Door seals worn
Removed the door by unscrewing two screws holding it to the springs. Then I placed the door face down on a counter top. I removed the screws from each layer of the door and turned each layer over and laid it beside the door. Took care to support glass so it did not fall out and break. When I got to the layer where the seal was, I removed the old seal and replaced it with the new one. Then, I replaced each layer in reverse order. You have to be careful when replacing the layer that goes over the seal that the seal remains in the right place. It has a tendency to slip out of place, so check it before tightening screws. To place the door back on the spring loaded handles, prop the handles open a ways with screw driver handles. This provides a gap so that the door will slip on easily
Was this instruction helpful to you?
Thank you for voting!
Customer:
peter from springfield, PA
Parts Used:
WPY04100514
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
Failed Broiler element
Removed back of stove - 4 screws on top, 3 underneath. Unplugged wires from element. Removed element - 2 screws in front and 2 in the back. Installed new element, plugged wires back in, reinstalled back panel.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the W123-C
31 - 37 of 37