All Installation Instructions for General Electric Wall Oven JT3500DF6WW

Customer:: Don from HASLET, TX
Parts Used:: WB21X10165
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

The oven was burning when cooking at same temperature we always cooked it on

there was one screw holding it on the back wall of the oven. It was easy enough that my daughter installed it with my guidance.

5 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Eugene from Hilton Head, SC
Parts Used:: WB24T10147
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver

Burnt Smell

Unplugged the Range and removed the two screws holding down the cook top. You do not need to remove the vent chamber at the rear of the range since the top lifts up about 4 inches. This should be enough room to get your hand onto the plug going to the door switch. Pull off the plug and remove the swich. Pop in the new one, put on the plug, reinstall the two screws and you are done!

Read the thread on "burnt smell" and DO NOT assume it is a burned out element. Follow your nose!!

8 of 17 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Carl from MENIFEE, CA
Parts Used:: WB25T10102
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Burnt out lamp bulb

Remove oven light lens cover, remove the bulb and replace it with a new one.

5 of 15 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Salih Hindas / from SPRNGFLD GDNS, NY
Parts Used:: WB21X10165
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Went well.

Changed the Temperature Sensor as you suggested, but the problem of 40 minutes to reach a temperature of 375 degrees F. remained the same.

2 of 6 people found this instruction helpful.

Was this instruction helpful to you?

JT3500DF6WW General Electric Wall Oven - Instructions