Models
>
RY28025
RY28025 Ryobi Trimmer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for RY28025
Viewing 3 of 3Keep searches simple, eg. "belt" or "pump".
This is a spool retainer for your trimmer. You may also know this part as a bump knob. It is a right-hand thread screw to remove and attach to your trimmer head. Inside the spool housing, it holds the...
No Longer Available
This is an OEM primer bulb, and it is sold individually. Pressing the bulb removes the air out of the carburetor. Fuel is then forced from the fuel tank, which flows through the fuel line and into the...
Special Order
$5.89
This spark plug is used for lawn and garden equipment engines, such as trimmers, hedge trimmers, leaf blowers, cultivators, edgers, tillers and power brooms. The spark plug delivers electric current f...
In Stock
$4.99
This spring or container fits gardening tools such as a trimmer. The spring works to recoil a starter rope. If your spring has been worn out, it can lose tension and even break. If the spring breaks, ...
Special Order
Special Order
Special Order
$3.99
This is a grass deflector assembly for a trimmer. Your model may have a straight deflector and a curved shaft deflector, and this one is considered the curved shaft deflector. Its purpose is to help p...
In Stock
This carburetor is for line trimmers.
Carburetor mixes air and gas before the fuel mix goes to the engine.
Wear work gloves to protect your hands and work in a well-ventilated area during this repair.
No Longer Available
Special Order
In Stock
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- JAE from MILL HALL, PA
- Parts Used:
- 308038010
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
THE DRIVE SPLINE IN THE MIDDLE OF THE SHAFT WOULD NOT ENGAGE
REPLACED LOWER SHAFT
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Irvin from BURR OAK, MI
- Parts Used:
- 308038010
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
bearing set up in lower shaft.
Purchased and replaced curved lower shaft assembly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- edward from ALLEN, TX
- Parts Used:
- 308054043
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Socket set
didn't keep running
removed outer cover, remove old gas lines from carburetor and gas tank. Unscrewed (2) screws holding carburetor. Making certain not to damage gasket under carburetor then installed carburetor using same gasket and screws that held it before. Tightened to snug fit. Installed new gas lines, and cover over carburetor.
Was this instruction helpful to you?
Thank you for voting!