RY28020 (RY28020) Ryobi Trimmer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- JAE from MILL HALL, PA
- Parts Used:
- 308038010
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
THE DRIVE SPLINE IN THE MIDDLE OF THE SHAFT WOULD NOT ENGAGE
REPLACED LOWER SHAFT
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Irvin from BURR OAK, MI
- Parts Used:
- 308038010
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
bearing set up in lower shaft.
Purchased and replaced curved lower shaft assembly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- edward from ALLEN, TX
- Parts Used:
- 308054043
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Socket set
didn't keep running
removed outer cover, remove old gas lines from carburetor and gas tank. Unscrewed (2) screws holding carburetor. Making certain not to damage gasket under carburetor then installed carburetor using same gasket and screws that held it before. Tightened to snug fit. Installed new gas lines, and cover over carburetor.
Was this instruction helpful to you?
Thank you for voting!