3707F Makita Trimmer - Parts

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing y...

This part includes two carbon brushes with wire leads and brush springs. Worn brushes are typically presented as a failed or underperforming motor. Carbon brushes are a part that commonly wears, so it...

This is a cord guard, also known as a strain reliever, for your power tools. Power tool cords go through a lot of stress during usage, and this part is designed to remove some of that stress from the ...

This is a self-tapping screw, and it is found on multiple power tools and lawn equipment. This screw is different because it can tap its own hole into tough materials, such as metals and hard plastics...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwis...

This item is a genuine Makita part that has been sourced from the original manufacturer to be used with trimmers, circular saws, sanders, routers, nailers, reciprocating saws, laminate trimmers, and p...

This replacement adjustment knob/screw is a genuine Makita part. It is supplied from original equipment manufacturer for use with belt sanders/trimmers. While the belt is running, use the adjusting kn...

This replacement pin is an authentic OEM component which is made for use with Makita equipment. The pin is generally utilized to secure a part while allowing it to rotate freely. It is a standard hard...

This part is available as an individual replacement part. The magnet sleeve goes between the stop ring and the wave washer. It is made of plastic and will require replacing if it becomes broken. A scr...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ...

This is a genuine manufacturer-sourced replacement part which is specially designed for use with Makita power tools. The purpose of the brush cap is to secure the brush in the housing, please make sur...