Models > BL160

BL160 (41AD160G965) Bolens Trimmer

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$35.86
It is an authentic manufacturer-sourced replacement part that i supplied for Craftsman trimmers. The function of a carburetor is to mix the air and the gas into a highly combustible mix before it goes...
In Stock
This bump knob assembly fits lawn and gardening tools, usually trimmers. This part bumps on the ground to advance the cutting line from the spool. With time and use, this part can wear out easily. It ...
In Stock
This is a genuine OEM replacement throttle trigger (red). The throttle trigger is responsible for managing the speed of the engine. The throttle cable attaches to the trigger, which connects to the th...
No Longer Available
This is an authentically sourced fuel tank assembly, including the fuel lines, fuel cap, fuel filter, and screws needed for assembly. This fuel tank assembly is for trimmers, and is where the fuel is ...
In Stock
This spool is for line trimmers. Spool houses the cutting line and fits inside the cutting head to cut grass and weeds. Wear work gloves to protect your hands when installing this part.
In Stock
$10.90
In Stock
In Stock
In Stock
In Stock
$10.70
This switch is used on a variety of trimmers, blowers and other similar gardening equipment. This switch controls the on and off operations of your tool. Switches have mechanical internals, which degr...
In Stock
Special Order
In Stock

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for BL160

Viewing 1 of 1
Will Not Start
Fixed by these parts
Fixing Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Erik from ROBERTSDALE, AL
Parts Used:
753-06183
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Fuel line broke
Removed the two screws holding the fuel tank to the main unit. Removed the two fuel lines and any stuck on rubber. Installed and installed two screws to mount the new tank. Slid fuel lines on their respective connectors. Done.
12 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
john from SHARPSVILLE, PA
Parts Used:
753-06253, 753-06190
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
string trimmer would not start
emptied fuel from tank. pulled off the 2 fuel lines from the carburetor.opened the air cleaner door. removed the 2 torque screws that hold on the carburetor. removed the carburetor and air cleaner gasket. installed new carburetor and gasket and put back and tightened the 2 torque screws. closed air cleaner door and pushed the fuel lines o nto the new carburetor.put some fuel in the tank. started the trimmer. runs great.
5 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Zachary from CANTON, NC
Parts Used:
753-06195
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers
Part didn't have cut outside for killswitch or spark plug wire
Had to cut plastic housing in order to get the part to fit.
If the new housing had the cut outside this would have been a simple 30 min repair.

Spend $5 more and get the right part from MTD/Bolens website.
3 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!