Models > TC507W > Instructions

TC507W Jenn-Air Trash Compactor - Instructions

Jump to:

All Instructions for the TC507W
91 - 105 of 116
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
john from red bluff, CA
Parts Used:
675382
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
broken rotary switch
remove drawer remove two phillip screws lift off front panel remove wiring and plug into new switch.slide switch through the hole in panel install nut reinstall panel screws and drawer job done.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dick from Penn Valley, CA
Parts Used:
WP777811
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Directional Switch lever broke
The part was suppose to come with instructions, but did not. However, it was easy after reading the comments on-line, and discovering that the front cover had to be removed in order to expose the whole switch and wires. I did drop one of the mounting screws down the front of the compactor and was not able to recover it. So, I had to make a trip to the hardware store for a replacement. They couldn't match the remaining screw but I found 2 similar ones with lock washers and nuts that worked just fine. I saved a $90 service charge and probably double the cost of the switch by doing it myself.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gerald from Wickenburg, AZ
Parts Used:
WP777811
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Wrench (Adjustable)
Unit cycled when on switch operated and would not stop until Off switch was activated.
Replaced the limit switch. This did not alter the problem. Took off the On/Off/Start switch and dissasembled. I found the the Start switch was stuck in the on position. I reassembled the switch mechanism assuring that the Red "ON" indicator moldings were correctly positioned and reassembled everything. The Compactor now works properly. Need to add "Check the Start switch" to diagnosis.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the TC507W
91 - 105 of 116